PC-116 Rust Inhibitive Epoxy Primer
PC-116 is a two component, fast curing high build Polyamide Epoxy Rust Inhibitive Primer designed for use as a primer for our epoxy and polyurethane topcoats. PC-116 helps prevent edge failure and film under-cutting of steel surfaces exposed to corrosive atmosphere and chemically aggressive environments. PC-116 can be used where an extended recoat period of up to 6 months is needed. Proper cleaning of the primer must be done after extended time without a top coat to remove any dust, dirt, grease or oil that may have contaminated the surface.
if this fits your vehicle.
Description
PRODUCT USES
Recommended for structural steel, tanks, vessels, equipment, pipe racks, etc., in chemical processing plants, pulp and paper mills, sewage and waste water treatment facilities, fertilizer plants, refineries, electric generating stations, coal handling sites, marine installations, etc.
PRODUCT FEATURES
Excellent rust preventing properties.
Excellent resistance to “under cutting”.
Long recoat up to 6 months.
Outstanding adhesion and “wetting out” ability.
Fast recoat times.
Great shop coat primer for fabricators.
Good flexibility and abrasion resistance
Excellent film build to protect sharp edges.
Additional information
| COLOR | Lt. Gray |
|---|---|
| GLOSS | Flat |
| VOLUME SOLIDS | 55% |
| V.O.C. | 3.36 lbs., 403 GMS/L |
| COVERAGE (Theoretical) | 864 sq. ft. @ 1.0 mils DFT |
| RECOMMENDED DRY FILM THICKNESS | 3-4 mils DFT @ 208-288 sq. ft. per gal. |
| MIXING RATIO | 1 by volume Mix 1 part Base (Part A) to 1 part Hardener (Part B) |
| INDUCTION TIME | 30 minutes |
| POT LIFE | 8 hrs. @ 75°F |
| APPLICATION | Spray, brush or roller |
| APPLICATION TEMP | 45° – 120°F |
| MIN. RECOAT TIME | 5-6 hours @ 75°F |
| DRY SERVICE TEMP | 200°F max. |
